Previous   IndexNext


Home
Gallery
Manual
Collectible items
FAQ
Parts
Links
Contact
Just for Fun
Tech Forum
Closed

Assembly
filling vents I have done the initial filling but will need to go back to clean it up a bit.
under dash Under the dash, the windshield wiper mechanism is cleaned up and mounted as well as the fresh air blower.
Bumper repairs The rear bumper had a couple of cracks and some of the mounting bolts pulled through the surface. This crack has been sanded out and is ready to be filled.
Bumper repair underway The glass matting has been laid in and is now clamped.
Vacuum bagging bumper I have ground out the old screw holes and filled them with a combination of carbon and glass fibers. I then vacuum bagged it. This probably was overkill but, hey, I had the equipment so I figured I should use it!
Previous   IndexNext

 

 




This site looks best at 800X600 24 bit color or greater. Many of the images are rather large to preserve as much of the original detail as possible.

Disclaimer:

This site is in no way associated with Bradley Automotive or it's successors (if any). The purpose of this site is to help disseminate information about and promote the Bradley GTII kit car. It is not the purpose of this site to infringe on any trademarks or copyrights that may still be claimed.

Copyright ©2000-2005 bradleygt2.com. All rights reserved.
Site Design by Pete Rondeau. No material may be used from this site without prior written consent.