Previous   IndexNext


Home
Gallery
Manual
Collectible items
FAQ
Parts
Links
Contact
Just for Fun
Tech Forum
Closed

Assembly
Headlights The headlights installed and open.
hole in trunk The previous owner had a carb and air cleaner combination that was too large to fit. Their solution was to hack a nasty looking hole in the fiberglass above it and in the engine cover.
repair underway Here I have started to repair the hole. After sanding the remaining edges to a taper I lay in fiberglass mat to replace the missing material. I then clamp it between pieces of mylar. This squeezes out the excess resin and ensures decent adhesion to the original surface.
fresh air vents I decided to change the fresh air source to below the car as instructed in later versions of the assembly manual. Here I have laid in glass mat as a backer for the patching I will do.
filling vents I have done the initial filling but will need to go back to clean it up a bit.
Previous   IndexNext

 

 




This site looks best at 800X600 24 bit color or greater. Many of the images are rather large to preserve as much of the original detail as possible.

Disclaimer:

This site is in no way associated with Bradley Automotive or it's successors (if any). The purpose of this site is to help disseminate information about and promote the Bradley GTII kit car. It is not the purpose of this site to infringe on any trademarks or copyrights that may still be claimed.

Copyright ©2000-2005 bradleygt2.com. All rights reserved.
Site Design by Pete Rondeau. No material may be used from this site without prior written consent.