Previous   IndexNext

Collectible items
Just for Fun
Tech Forum

Turning new bushing It occured to me that these bearings were probably a little overkill for the low speed the headlights operate at. I also figured if I replaced them eventually they would sieze up again. I decided to push the bronze bushing out of it's carrier and replace it with a bushing turned from UHMW plastic. Now, the only reason I did this was because I happen to have a lathe and a ready supply of plastic. Otherwise I probably would have just replaced them.
Unfinished parts Here are the pieces of what will be the headlight assembly prior to finishing.
Finished pieces Here are the same pieces after sandblasting and powder coating. The new plastic bushings are also in place.
Headlight motor Headlight motor installed. This is the larger Fiat x/19 motor. With this motor the bracket with the up-down limit switches is no longer needed.
Headlight bracket Wheel well view of the headlight bracket.
Previous   IndexNext



This site looks best at 800X600 24 bit color or greater. Many of the images are rather large to preserve as much of the original detail as possible.


This site is in no way associated with Bradley Automotive or it's successors (if any). The purpose of this site is to help disseminate information about and promote the Bradley GTII kit car. It is not the purpose of this site to infringe on any trademarks or copyrights that may still be claimed.

Copyright ©2000-2005 All rights reserved.
Site Design by Pete Rondeau. No material may be used from this site without prior written consent.